Ahoj tě , pokouším se obnovit dle návodu , nemužu to přehrat na sapro.img . Ted je tam nebo my svity na panelu USBsda1PTK .
*************************************************************
************************************************
Board - STi7111 Vitamin 5000 HD
U-boot with Boot selection
-=*[
http://www.pkteam.pl ]*=-
************************************************
*************************************************************
U-Boot 2008.10 (Aug 8 2013 - 18:16:44) - stm24-2012-04-25
DRAM: 256 MiB
NOR: 8 MiB
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
VITAMIN> sapro_upgrade
[upgrade] usb_read(): (Re)start USB...
USB: scanning bus for devices... 3 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading sapro.img
.
.................
*************************************************************
************************************************
Board - STi7111 Vitamin 5000 HD
U-boot with Boot selection
-=*[
http://www.pkteam.pl ]*=-
************************************************
*************************************************************
U-Boot 2008.10 (Aug 8 2013 - 18:16:44) - stm24-2012-04-25
DRAM: 256 MiB
NOR: 8 MiB
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
## Booting kernel from Legacy Image at a0080000 ...
Image Name: Linux-2.6.32.46_stm24_0209
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 1848193 Bytes = 1.8 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting kernel:
start = 0x80802000
initrd = 0x00000000 (0 bytes)
bootargs = console=ttyAS0,115200 root=/dev/sda1 rw ip=192.168.1.102:192.168.1.1:192.168.1.1:255.255.255.0:eth0:off mem=256m coprocessor_mem=4m@0x40000000,4m@0x40400000 rootdelay=6 nwhwconf=device:eth0,hwaddr:00:03:91:12:34:57 init=/bin/devinit