Smartreader a Bus a Device na ubuntu

[Patrik1974]

Caute taka otazk ako sa da natvrdo nakonfigurovat ked dam do usb citacku smargo prideli jej linux bus a device, ktore potom nadefinujem do oscamu, ale ked ju potom vytiahnem a dam zase spat do toho isteho portu sa zmeni bus a device a jako chuj to zase musim prepisovat v oscam.server subore aby ju videl.
Dik .PAtrik.

[marian34]

Dobre rano, http://www.ab-forum.info/viewtopic.php?f=166&t=44735

[marecek29]

Nebo:
cat /proc/bus/usb/devices

T: Bus=01 Lev=02 Prnt=03 Port=03 Cnt=03 Dev#= 6 Spd=12 MxCh= 0
D: Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0403 ProdID=6001 Rev= 4.00
S: SerialNumber=Reader 8442B01
C:* #Ifs= 1 Cfg#= 1 Atr=a0 MxPwr=100mA
I:* If#= 0 Alt= 0 #EPs= 2 Cls=ff(vend.) Sub=ff Prot=ff Driver=ftdi_sio
E: Ad=01(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms

SUBSYSTEMS=="usb", KERNEL=="ttyUSB*", ATTRS{serial}=="Reader 8442B01", SYMLINK+="smargo1"

device = /dev/smargo1

[Patrik1974]

Dobre rano, http://www.ab-forum.info/viewtopic.php?f=166&t=44735

Pre mna je to dobre rano iba odteraz lebo doteraz som s tym nemal problem ziaden doinstaloval som apcupsdeamona a dal pc na smart upsku a kua problem takze tak.....